Display assembly
Description
Spare part number
Display panel assembly, touch screen (whole hinge-up)
NOTE:
Touch displays are spared only as whole hinge-ups.
NOTE:
Non-touch display assemblies are spared at the subcomponent level only.
L22363-001
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
).
5.
Remove the battery (see
6.
Remove the following components:
a.
WLAN module (see
WLAN/Bluetooth combo card on page 39
)
b.
WWAN module (see
)
Remove the display assembly:
1.
Open the computer and then position it upside down with the display hanging off the side of a table so
that the hinges are open.
2.
Remove the 4 Phillips M2.5×5.0 screws (1) from the display hinges.
3.
Disconnect the display cable (2) and camera cable (3)(select models only) from the system board.
4.
Remove the WLAN antennas and WWAN antennas (if equipped)(4) from the routing path along the base
of the computer.
Component replacement procedures
65
