Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
To replace the service door:
1.
Tilt down the service door to align the front edge of the service door near the front edge of the
computer
(1)
.
2.
Insert the alignment tabs
(2)
on the rear edge of the service door with the notches on the
computer.
3.
Slide the service door toward the battery bay until the service door snaps into place.
4.
With the battery bay toward you, slide the service door release latch to the left
(3)
, and if you
choose to, insert and tighten the optional screw
(4)
to hold the service door in place. Slide the
release latch to the right to lock the service door
(5)
.
NOTE:
If you want to use the optional screw, it is stored inside the service door.
5.
Insert the battery (see
Inserting or removing the battery on page 32
).
34
Chapter 5 Maintenance
