VGA port board
Description
Spare part number
VGA port board
690641-001
Before removing the VGA port board, follow these steps:
IMPORTANT:
Make special note of each screw and screw lock size and location during removal
and replacement.
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
).
6.
Remove the following components:
a.
Hard drive (see
b.
Upgrade bay device (see
).
c.
Keyboard (see
d.
Top cover (see
Remove the VGA port board:
1.
Position the computer right-side up with the front toward you.
2.
Remove the Phillips screw
(1)
that secures the VGA port board to the base enclosure.
3.
Remove the two Torx 8 screws
(2)
that secure the VGA port board to the base enclosure.
98
Chapter 4 Removal and replacement procedures
