Display assembly
Description
Spare part number
39.6-cm (15.6 in) FHD RGB UWVA LCD display assembly with DreamColor:
For use in computer models without webcams
690627-001
For use in computer models with webcams
690626-001
NOTE:
It is not necessary to remove the display panel in order to remove the display assembly.
However, for access to the webcam module, WLAN module, or WWAN module, you must remove the
display panel. For display panel removal instructions, see
Display panel (non-DreamColor) on page 55
Before removing the display assembly, follow these steps:
IMPORTANT:
Make special note of each screw and screw lock size and location during removal
and replacement.
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
(Optional) Remove the display panel (see
Display panel (non-DreamColor) on page 55
)
6.
)
7.
Disconnect the wireless antenna cables from the WLAN module (see
and the WWAN module (see
8.
Remove the following components:
a.
Hard drive (see
b.
Upgrade bay device (see
).
c.
Keyboard (see
d.
Top cover (see
Remove the display assembly:
1.
Position the computer right side up, with the display closed and the rear toward you.
2.
Remove the four Torx T8M2.5×4.5 screws
(1)
that secure the display hinge cover to the base
enclosure.
130
Chapter 4 Removal and replacement procedures