Display assembly components (panel, bezel, webcam, microphone)
CAUTION:
Be sure to disconnect the battery cable before removing any components from the computer.
All display assemblies include WLAN antenna transceivers and cables.
This section describes removing components from non-touch displays that do not require that you entirely
remove the display assembly from the computer. You can remove the display bezel, webcam/microphone
module, and display panel with the display assembly still attached to the computer.
To remove the remaining components from non-touch displays, including the hinges, panels, and cables, you
must remove the entire display assembly from the computer. See
Display assembly on page 45
for more
information about removing the remaining components.
Description
Spare part number
NOTE:
Non-touch display assemblies are spared at the subcomponent level only.
Touch displays are only spared as full hinge-ups. Individual components are not spared for touch screen displays.
Raw display panels
(35.6-cm [14.0-in], anti-glare, LED)
QHD display panel, non-touch
790070-001
FHD display panel, non-touch
790071-001
Display bezel
790046-001
Webcam module
790068-001
Before removing the display panel, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
Bottom cover on page 32
).
34
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
