Display assembly
This section describes removing components that require you to completely remove the display panel. You
can remove the display bezel, webcam, and display panel without removing the entire display hinge-up from
the computer.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
Bottom cover on page 32
).
5.
Disconnect the battery cable.
Remove the display assembly:
1.
Open the computer and position it with the base enclosure on a table and the display hanging down.
Component replacement procedures
45
