Service door
Description
Spare part number
Service door (includes 4 captive retention screws and 2 rubber feet)
753713-001
Before removing the service door, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 28
).
Remove the service door:
1.
Turn the computer upside down, with the front toward you.
2.
Press on the memory card bezel
(1)
once to release the bezel, and then press on the bezel again
to remove the bezel.
3.
Remove the two large rubber screw covers
(2)
.
4.
Remove the two Phillips M2.0×6.5 screws
(3)
that secure the service door to the computer.
5.
Remove the two small rubber screw covers
(4)
.
The large and small rubber screw covers are included in the Plastics/Rubber Kit, spare part
number 753713-001.
6.
Remove the two Phillips M2.0×8.5 screws
(5)
that secure the service door to the computer.
7.
Loosen the four captive Phillips screws
(1)
that secure the service door to the computer.
30
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for EliteBook Revolve 810 G2 Tablet
