NFC board
Description
Spare part number
NFC board (includes NFC board cable)
753717-001
Before removing the NFC board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 28
).
5.
Remove the service door (see
Service door on page 30
).
Remove the NFC board:
1.
Disconnect the NFC antenna cable
(1)
from the NFC board.
The NFC antenna cable is included in the Top cover spare part kit, spare part number .
2.
Release the zero insertion force (ZIF) connector
(2)
to which the NFC board cable is attached,
and then disconnect the NFC board cable from the system board.
3.
Remove the Phillips M1.5×2.0 screw
(3)
that secures the NFC board to the Top cover. (The NFC
board cable is attached to the Top cover with double-sided tape.)
4.
Remove the NFC board
(4)
and cable.
Reverse this procedure to install the NFC board.
40
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Summary of Contents for EliteBook Revolve 810 G2 Tablet
