6.
Detach the button board
(1)
from the top cover. (The button board cable is attached to the the top
cover with double-sided tape.)
7.
Remove the Phillips M2.0×3.0 screw
(2)
that secures the button board to the top cover.
8.
Remove the button board
(3)
.
Reverse this procedure to install the button board.
RTC battery
Description
Spare part number
RTC battery (includes cable and double-sided adhesive)
716742-001
Before removing the RTC battery, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 28
), and then remove the following components:
a.
Service door (see
Service door on page 30
)
b.
Keyboard (see
Keyboard on page 41
)
c.
Top cover (see
Top cover on page 45
)
Remove the RTC battery:
1.
Disconnect the RTC battery cable
(1)
from the system board.
Component replacement procedures
51
Summary of Contents for EliteBook Revolve 810 G2 Tablet
