Removing the hard drive
To remove a hard drive:
1.
Save your work and shut down the computer.
2.
Disconnect AC power and external devices connected to the computer.
3.
Turn the computer upside down on a flat surface.
4.
Remove the battery and the battery bay cover(see
Removing a battery on page 44
).
5.
Loosen the 1 hard drive screw. Pivot the hard drive to a forty-five degree angle, and then lift it
from the hard drive bay. The hard drive is an SSD, which does not resemble conventional hard
drives.
Installing a hard drive
NOTE:
Your computer may look slightly different from the illustration in this section.
To install the hard drive:
1.
Insert the hard drive into the hard drive bay at an angle, and then lay the hard drive flat in the
hard drive bay.
2.
Tighten the hard drive screw.
3.
Replace the service door (see
Replacing the service door on page 55
).
4.
Insert the battery (see
Inserting a battery on page 44
).
5.
Connect AC power and external devices to the computer.
6.
Turn on the computer.
56 Chapter 8 Drives
ENWW
Summary of Contents for EliteBook Revolve 810 G2 Tablet
