3.
Place the fingerprint reader (1) on the riser (2), and then attach the mounting bracket (3) and cable
routing clip (4) to the fingerprint reader and riser with the two long screws (5) included with the
fingerprint reader.
4.
Connect the USB cable to the fingerprint reader (1) and route the cable under the routing clip on the
fingerprint reader (2). Remove the mounting screw (3) from the underside of the I/O connectivity base,
and then attach the bracket on the fingerprint reader assembly to the underside of the I/O connectivity
base (4) using the screw that was removed from the base and the short screw included in the kit.
28
Chapter 3 Hardware configurations and upgrades
Summary of Contents for Engage Go Convertible System
Page 4: ...iv About This Book ...
Page 8: ...viii ...