c.
RJ45 cover (see
RJ45 cover on page 48
)
d.
Security cable slot bracket (see
Security cable slot bracket on page 50
)
e.
System board (see
System board on page 51
)
Remove the power connector cable:
1.
Remove the Phillips PM2.0×3.3 screw (1) that secures the power connector cable and bracket to
the top cover.
2.
Remove the power connector cable bracket (2).
The power connector cable bracket is available using spare part number 818117-001.
3.
Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Display assembly
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
Bottom cover on page 27
).
5.
Disconnect the battery cable from the system board (see
Battery on page 37
).
6.
Remove the RJ45 cover (see
RJ45 cover on page 48
).
7.
Remove the security cable slot bracket (see
Security cable slot bracket on page 50
).
Remove the display assembly:
Component replacement procedures
61
