48
Follow these steps to solve system faults:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Specify the system fault solving
method for the MPU
system-failure
{
maintain
|
reboot
}
Optional
reboot
by default for the MPU.
NOTE:
•
Rebooting the MPU reboots the firewall.
•
If an interface module encounters software faults, the solving method is always reboot, which reboots the
failed module.
•
When system faults occur, the system fault solving method applies to only the failed module, and
rebooting the module does not interrupt the other modules.
Viewing the system fault solving method
Use the
display system-failure
command to display the system fault solving method.
<Sysname> display system-failure
System failure handling method: reboot
Saving the current configuration of the firewall
You can save the current configuration of the firewall in one of the following methods:
•
Fast saving: Executing the
save
command without the
safely
keyword. This mode saves the file more
quickly but is likely to lose the existing configuration file if the firewall reboots or the power fails
during the process. The fast saving mode is suitable for environments where the power supply is
stable.
•
Safe saving: Executing the
save
command with the
safely
keyword. The mode saves the file more
slowly but can retain the configuration file in the firewall even if the firewall reboots or the power
fails during the process. The safe saving mode is preferred in environments where a stable power
supply is unavailable or remote maintenance is involved.
Follow these steps to save the current configuration of the firewall:
To do…
Use the command… Remarks
Save the current configuration to the specified file, but the
configuration file will not be set as the file for the next startup
save
file-url
[
all
|
slot
slot-number
]
Use either command
Available in any
view
Save the current configuration to the root directory of the
storage medium of the MPU and specify the file as the startup
configuration file that will be used at the next system startup
save
[
safely
]
NOTE:
•
The configuration file must be with extension .cfg.
•
During the execution of the save command, the startup configuration file to be used at the next system
startup may be lost if the firewall reboots or the power supply fails. In this case, the firewall will boot with
the factory defaults, and after the firewall reboots, you need to re-specify a startup configuration file for
the next system startup.
Summary of Contents for F5000
Page 6: ...iv Index 92 ...
Page 11: ...5 Fan trays Figure 9 Fan tray 1 Handle 2 Fans ...
