27
-
In this mode, the camcorder is in standby mode until event
happens. This mode will consume more battery power.
-
To disable this function, in the standby mode or motion detection
recording, press any key to wake up the screen, and resume to
normal loop recording; or when the car engineer is started again,
it will be back to normal loop recording.
•
Vibration Detection:
-
If disconnected external power supply when the camcorder is
powered on, the system alert message “
Press OK to power off or
enter Vibration Detection after 10 sec.
” This means the system
will power off and enter Vibration Detection automatically in 10
seconds.
-
Once Vibration Detection Mode is triggered, when the camcorder
detects any vibration, it will automatically power on and start
recording, the event will be recorded for 60 seconds (per file).
-
In this mode, car camcorder is powered off until event happens.
This mode is more power saving.
-
To disable this function, in the vibration detection recording, press
any key to wake up the screen, and resume to normal loop
recording; or when the car engineer is started again, it will be back
to normal loop recording.
Note:
1. When
Motion Detection
or
Vibration Detection
triggers, the camcorder records
events taken by front camera only.
2. If battery in a fully charged condition, it can record about 30 minutes video in
Motion Detection
mode. As the camcorder is used, the battery storage capacity will
decrease gradually. This is a normal phenomenon for the battery.
3. The video files taken in Motion Detection mode will be saved in normal recording
folder.
4. The video files taken in Vibration Detection mode will be saved in Event recording
folder, which will not be overwritten by normal video files.