43
Powering on the switch
IMPORTANT:
Before powering on the switch, identify the power switch in the equipment room so that you can disconnect
the power module promptly in case of an emergency.
Before powering on the switch, verify that:
•
The interface cables, power cords, and the grounding cable are correctly connected.
•
The input power voltage meets the requirement of the switch.
•
The console cable is correctly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
Powering on the switch
1.
Turn on the power switch of the power source.
2.
Turn on the power switch on the switch.
After the switch is powered on, the basic manufacturing information about the switch is displayed:
DDR2 SDRAM test successful.
System is starting...
Booting Normal Extend BootWare
The Extend BootWare is self-decompressing
Done!
****************************************************************************
* *
* HP 12500 BootWare, Version 2.20 *
* *
****************************************************************************
Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P.
Compiled Date : Sep 4 2013
CPU Type : P5040
CPU L1 Cache : 32KB
CPU L2 Cache : 1024KB
CPU Clock Speed : 1800MHz
Memory Type : DDR3 SDRAM
Memory Size : 8192MB
Memory Speed : 1200MHz
BootWare Size : 8MB
Flash Size : 512MB
cfa0 Size : 4002MB
NVRAM Size : 1024KB
BASIC CPLD Version : 001
EXTENDED CPLD Version : 001
PCB Version : Ver.A
The switch initiates the power-on self-test (POST) and the results are displayed at the console
terminal.
