39
Configuring packet resequencing
When the network traffic is out of sequence, some systems that cannot resequence packets, such as
a video conferencing terminal, might encounter mosaic. The packet resequencing function can
alleviate the problem.
To configure packet resequencing:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Enable packet
resequencing.
qos resequencing
By default, packet resequencing is
disabled.
After you enable or disable packet
resequencing, to make the
configuration take effect, you must
re-enable the interface by using the
shutdown
and
undo shutdown
command sequence.
Displaying and maintaining traffic policing, GTS,
and rate limit
Task Command
Remarks
Display CAR list information.
display qos carl
[
carl-index
] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
Available in any
view.
Display the CAR information on
the specified interface.
display qos car interface
[
interface-type
interface-number
] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
Available in any
view.
Display interface GTS
configuration information.
display qos gts interface
[
interface-type
interface-number
] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
Available in any
view.
Display interface rate limit
configuration information.
display
qos lr interface
[
interface-type
interface-number
] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
Available in any
view.
Traffic policing and GTS configuration examples
Traffic policing and GTS configuration example
Network requirements
As shown in
:
•
Server, Host A, and Host B can access the Internet through Router A and Router B.
•
Server, Host A, and GigabitEthernet 1/0/1 of Router A are in the same network segment.
•
Host B and GigabitEthernet 1/0/2 of Router A are in the same network segment.
