547
Step Command
Remarks
3.
Set the MPLS TE tunnel
establishment mode to
static.
mpls te signaling static
By default, MPLS TE uses
RSVP-TE to establish a tunnel.
4.
Bind a static SRLSP to the
MPLS TE tunnel interface.
mpls te static-sr-lsp
lsp-name
By default, an MPLS TE tunnel
does not use a static SRLSP.
Displaying and maintaining static SRLSP
Execute
display
commands in any view.
Task Command
Display static SRLSP and adjacency path
information.
display mpls static-sr-lsp
[
lsp
lsp-name
|
adjacency
adjacency-path-name
]
Static SRLSP configuration examples
Network requirements
As shown in
, Router A, Router B, Router C, Router D, Router E, and Router F run IS-IS.
Establish an MPLS TE tunnel over a static SRLSP from Router A to Router D to transmit data
between the IP networks. The static SRLSP traverses three segments: Router A-Router B, Router
B-Router C, and Router C-Router D.
Establish an MPLS TE tunnel over a static SRLSP from Router E to Router F to transmit data
between the IP networks. The static SRLSP traverses three segments: Router E-Router B, Router
B-Router C, and Router C-Router F.
