97
FIP-240 specifications
Item Remarks
Memory type and size
•
Default
—One 2-GB DDR3 SDRAM
•
Maximum
—Two 2-GB DDR3 SDRAMs
NVRAM 128
KB
Combo interface
2
2 copper ports (MDI/MDIX
autosensing)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 fiber ports
1000 Mbps, full-duplex
MIM 4
supported
HIM
2 full-height or 4 half-height HIMs supported
(Half-height HIMs include HIM-4G4P, HIM-TS8P, and HIM-8GBP-V2.)
Hardware encryption
Supported
Hot swapping
Supported
NOTE:
•
For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the
combo
enable { copper | fiber }
command in interface view. For more information about the
combo
enable
{
copper
|
fiber
} command, see
HPE FlexNetwork HSR6800 Routers
Interface
Command Reference
.
•
Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-240 combo interface specifications
Specification of combo interfaces on the FIP-240 and the FIP-110 are the same. For more
information, see
and
Transceiver modules available for the FIP-240 fiber ports are the same. For more information,
see
.
Maximum interface modules provided by FIP-240 in full configuration
FIP/Interface
module
HSR6802 HSR6804 HSR6808
FIP-240 2
4
8
MIM 8
16
32
HIM
4 (8 half-height HIMs)
8 (16 half-height HIMs)
16 (32 half-height HIMs)
FIP-300
The FIP-300 supports HIMs and MIMs, and it provides 12 combo interfaces.
