iLO
Parameters
343
Secure Shell (SSH) Status
This setting enables you to specify if the SSH feature on iLO is enabled or
disabled. The default is enabled.
•
•
•
Network Settings Parameters
Serial Command Line Interface Status
Enabled (authentication required)
Enabled (no authentication)
The default setting is Enabled—authentication required.
This setting enables you to change the speed of the serial port for the CLI feature
through the serial port. Valid speeds are (bits/s) 9,600, 19,200, 38,400, 57,600
and 115,200. The default setting is 9600 bits/s. The serial port configuration must
be set to No parity, 8 data bits, and 1 stop bit (N/8/1) for proper operation. The
serial port speed set by this parameter must match the speed of the serial port set
in the System ROM RBSU setup.
This option specifies the minimum number of characters allowed when a user
password is set or changed. The character length can be set at a value from zero
to 39. The default setting is eight characters.
This setting allows you to specify the language model of the keyboard during a
Remote Console session. The default setting is US.
The following parameters provide information about the iLO network settings.
This setting allows you to change the status of the CLI feature through the serial
port. Valid settings are:
Disabled
Serial Command Line Interface Speed (bits/second)
Minimum Password Length
Remote Keyboard Model
Summary of Contents for HP Integrated Lights-Out
