Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-3
Memory module descriptions and part numbers
Description
Spare part number
16 GB, DDR4-3200
L67710-002
8 GB, DDR4-3200
L46598-002
4 GB, DDR4-3200
L83673-002
Before removing the memory, follow these steps:
1.
Prepare the computer for disassembly (see
Preparation for disassembly on page 32
2.
Remove the bottom cover (see
).
3.
Disconnect the battery cable from the system board (see
If you are replacing a memory module, remove the existing memory module:
1.
Lift the protective shielding to access the memory modules.
2.
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
To prevent damage to the memory module, hold the memory module by the edges only.
Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1.
Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot
at an angle until it is seated (2).
Component replacement procedures
35
Summary of Contents for HP ProBook 445 G8
Page 4: ...iv Safety warning notice ...
