NOTE:
For volume groups that support bootable PVs (Version 1.0 and Version 2.2 or higher),
lvmove
will not move root, boot, swap, or dump PVs.
The
lvmove
migration will fail for a space efficient snapshot that has pre-allocated extents. For
more information about snapshots, see
“Creating and Administering Snapshot Logical Volumes”
(page 103)
Administering File System Logical Volumes
This section describes special actions you must take when working with file systems inside logical
volumes. It addresses the following topics:
•
“Creating a File System” (page 97)
•
“Extending a File System” (page 98)
•
“Reducing the Size of a File System” (page 99)
•
“Backing Up a VxFS Snapshot File System” (page 101)
TIP:
When dealing with file systems, you can use HP SMH or a sequence of HP-UX commands.
For most tasks, using HP SMH is quicker and simpler. You do not have to explicitly perform each
of the following distinct tasks; rather, proceed from the HP SMH Disk and File Systems area. HP
SMH performs all the necessary steps for you.
Creating a File System
When creating either an HFS or VxFS file system in a logical volume, you can use HP SMH or a
sequence of HP-UX commands. If you choose to use HP-UX commands directly, the following list
describes the subtasks for creating a file system.
1.
If you create a new file system of a type other than HFS, you might need to reconfigure the
new type into the kernel. Normally, VxFS has been configured into the kernel as part of the
default configuration. See HP-UX System Administrator's Guide: Configuration Management
for information on how to add a file system type.
2.
Estimate the size required for the logical volume. To estimate the size requirements for a logical
volume containing a file system, see
“Setting Up Logical Volumes for File Systems” (page 21)
.
3.
Determine if there is sufficient disk space available in the volume group. Use the
vgdisplay
command to calculate this information, as described in
“Creating a Logical Volume” (page 52)
.
If there is not enough space within the volume group, you can add a disk to the volume group,
as described in
“Adding a Disk to a Volume Group” (page 51)
.
4.
Create the logical volume. Use
lvcreate
, as described in
“Creating a Logical Volume”
(page 52)
.
Administering File System Logical Volumes
97
