IMPORTANT:
Hewlett Packard Enterprise does not recommend setting the
Minimum Password Length
to
fewer than eight characters unless you have a physically secure management network that does
not extend outside the secure data center.
More information
Configuring iLO access options on page 228
IPMI/DCMI users
The iLO firmware follows the IPMI 2.0 specification. When you add IPMI/DCMI users, the login name
must be a maximum of 16 characters, and the password must be a maximum of 20 characters.
When you select iLO user privileges, the equivalent IPMI/DCMI user privilege is displayed in the
IPMI/
DCMI Privilege based on above settings
box.
•
User
—A user has read-only access. A user cannot configure or write to iLO, or perform system
actions.
For IPMI User privileges: Disable all privileges. Any combination of privileges that does not meet the
Operator level is an IPMI User.
•
Operator
—An operator can perform system actions, but cannot configure iLO or manage user
accounts.
For IPMI Operator privileges: Enable Remote Console Access, Virtual Power and Reset, and Virtual
Media. Any combination of privileges greater than Operator that does not meet the Administrator level
is an IPMI Operator.
•
Administrator
—An administrator has read and write access to all features.
For IPMI Administrator privileges: Enable all privileges.
Viewing local user accounts
Procedure
1.
Click
Administration
in the navigation tree.
The
User Administration tab
is displayed.
The
Local Users
table shows the login names, user names, and assigned privileges of each
configured user.
2.
Optional: To view a privilege name, move the cursor over a privilege icon.
iLO directory groups
iLO enables you to manage directory group accounts. Use MMC or ConsoleOne to manage directory-
based user accounts.
206
IPMI/DCMI users
