Working with enclosures, frames, and chassis
Using the Active Onboard Administrator
OA is the enclosure management processor, subsystem, and firmware base that supports the HPE
BladeSystem and all managed devices in the enclosure.
The
Active Onboard Administrator
page allows you to view enclosure information, start the OA web
interface, and toggle the enclosure UID LED. This page is displayed only when an enclosure is present.
Viewing OA information
Procedure
Click
BL c-Class
in the navigation tree.
This page provides general information about the primary OA in the enclosure in which the iLO processor
is located.
OA details
•
MAC Address
—The MAC address of the active OA.
•
System Health
—The health of the active OA, as reported by the OA.
A value of
unknown
means that the OA health has not been reported to iLO.
•
Blade location
—The location (enclosure bay) of the blade that is hosting the current iLO session.
•
Enclosure name
—The enclosure that the active OA is managing. You can change this value through
the OA.
•
Rack name
—The rack that contains the enclosure managed by the active OA. You can change this
value through the OA.
Starting the OA GUI
Procedure
1.
Click
BL c-Class
in the navigation tree.
2.
If the OA supports multiple addresses, select the address to use from the options in the
Onboard
Administrator Address Selection
table.
Depending on the configuration, the following options might be available:
•
IPv4
•
IPv6 SLAAC
•
IPv6 Static
•
IPv6 DHCP
3.
Click
Launch
.
Working with enclosures, frames, and chassis
293