14
4.
Fasten the captive screws on the FIP module with a Philips screwdriver.
Figure 12
Installing a FIP module
NOTE:
For more information about the FIP LEDs, see “
Installing a HIM/MIM
NOTE:
•
Install the MIM in the lower slot on the FIP module.
•
Only the FIP-20 supports HIMs.
•
Before you install a HIM, make sure that the ejector levers are in the open position away from the HIM
module panel.
The procedures for installing HIMs and MIMs are similar. This example installs a MIM to a FIP-20.
To install a MIM:
1.
Locate the slot to install the MIM on the FIP module.
2.
Loosen the captive screws on a filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router. Keep the filler panel safe for future
use.
3.
Use even pressure to push the MIM slowly along the slide rails into the slot, and then pull the levers
inward.
4.
Use a flat-blade screwdriver to fasten the captive screws on the MIM.
