4491+0 records out
4709154816 bytes (4.7 GB) copied, 957.784 seconds, 4.9 MB/s
5.
Insert the USB key into the server to be installed.
6.
Restart the server to boot from the USB key. (Press
F11
and use option
3
).
7.
When the “HP Network Storage System” screen appears, enter
qr
to install the software.
Repeat steps 5–8 on each server and then go to the next section, “Starting the installation and
configuration.”
Starting the installation and configuration
Complete the following steps:
1.
Boot the servers that will be in the cluster.
2.
The setup wizard checks the network for an existing cluster. If a cluster is found, you will be
asked if you want to join an existing cluster or create a new cluster.
If there is not an existing cluster or you chose to create a new cluster, the setup process asks
for information about the server you are using. On the System Date and Time dialog box,
enter the system date (day/month/year) and time (in 24-hour format). Tab to the Time Zone
field and press
Enter
to display a list of time zones. Select your time zone from the list.
3.
The Server Networking Configuration dialog box defines the server on
bond0
. Note the
following:
•
The hostname can include alphanumeric characters and the hyphen (
–
) special character.
It is a best practice to use only lowercase characters in hostnames; IBRIX issues can occur
with uppercase characters. Do not use an underscore (
_
) in the hostname.
•
The IP address is the address of the server on
bond0
.
8
Installing X9300 and X9320 systems
