Installation Manual
CA294-03070 rev 00
page 47 of 153
Figure 31 Leveling at the printing engine input – PE2 shown
2
1
WARNING
WARNING
AVERTISSEMENT
1 Level
2 Idler
b.
Place the level at the following positions, and level the printing engine:
•
On the input idler (Figure 31)
•
Exit idlers. Remove the ILD securing bracket and place aside temporarily.
If necessary, adjust the leveling pads until the printing engine is level.
Use a 19 mm wrench to turn the nut at the front of the pads to adjust the level.
If necessary, use the following to adjust the position and level of the engine:
•
A long crow-bar to slightly adjust the position of the engine.
•
2 mm spacers placed between the pads and the engine frame. Use a
lift-jack to slightly raise the engine and insert the pads.
Level to an accuracy of 0.00 ± 0.01 mm.
c.
After the printing engine is level, make sure that the four wheels are not in contact
with the ground.
If not, use the pads to lift the wheels evenly off the ground.
d.
Make sure that the printing engine is still level. Re-level if required.
e. Repeat
steps
a through d to level the remaining printing engine.
NOTE:
There are two parts to the printing engine alignment
procedure. The first part uses the alignment jigs to align both
printing engines horizontally. The second part uses the
