Installation Manual
CA294-03070 rev 00
page 21 of 153
The short configuration is used to align the remaining roller in each stepping plate to its companion
roller aligned previously (Figure 4).
To assemble the new Parallel jig to align two rollers (Figure 4):
1.
Insert the measuring gauge fixture into the desired extension (long, intermediate, short).
Tighten the handle.
2.
Insert the extension into the base so that the V-section and the gauge are facing the same
direction.
Tighten the two handles to secure the extension.
NOTE:
Disassembly is the reverse of the above two steps.
Figure 5 Mounting the v-section of the Parallel jig
1 Base
v-section 2 Roller
3.
Mount the v-section on the first roller (Figure 5).
Make sure that the extension reaches the second roller and tighten the extension securing
screws.
