Error light, Warning light, and Resume light
●
Printhead lights and Error light are off.
Warning light and Resume light are blinking quickly.
Cause
Solution
One of the following might have occurred:
–
The printer receives a printing job, and detects that there
is no paper in the input tray.
–
There is a paper jam.
–
Load paper, and then press the Resume button (
) to
continue printing.
For information about how to load paper, see
.
–
Clear the jam, and then press the Resume button (
)
to continue printing.
For more information, see
.
●
Warning light is off.
Printhead lights, Error light, and Resume light are blinking quickly.
Cause
Solution
The carriage inside the printer has stalled.
Open the front door and the printhead access door, and make
sure the printhead latch is properly closed and the print
carriage is not obstructed. If needed, slide the print carriage to
the right side of the printer. Close the printhead access door
and the front door, and then press the Resume button (
)
to continue printing. See
for more information.
NOTICE:
After you have set up the printer, do not open the
printhead latch unless instructed to do so.
●
Error light is off.
Warning light is blinking.
Other control panel lights remain unchanged.
ENWW
Status lights
9
