Log in to the RMC as
root
with the default password “root”, as in this example:
asylum$ ssh root@mc990x-rmc
root@mc990x-rmc's password:
root
MC990 X RMC, Rev. 1.1.xx [Bootloader 1.1.x]
RMC:r001i01c>
help
NOTE:
HPE recommends changing all default logins and passwords.
Once a connection to the RMC is established, system control commands can be entered. See
on page 15 for some examples.
See
Powering up and down from the command line interface
on page 17 for additional specific
examples of using the CLI commands.
Example CLI commands used
The following is a list of some available CLI commands:
auth
authenticate SSN/APPWT change
bios
perform bios actions
bmc
access BMC shell
rmc
access RMC shell
config
show system configuration
console
access system consoles
help
list available commands
hel
access hardware error logs
hwcfg
access hardware configuration variable
leds
display system LED values
log
display system controller logs
power
access power control/status
Example CLI commands used
15