Appendix C
Utilities
Specifying SCSI Parameters
187
Last Clear time: 10/21/01
5:00p
Number of total entries in PDT:
50
Number of used entries in PDT:
0
Number of free entries in PDT:
50
Number of single-bit entries in PDT:
0
Number of multi-bit entries in PDT:
0
Address of first multi-bit error: 0x0000000000000000
sysmode
Display or modify the system mode.
Syntax
sysmode <normal | admin| service>
Parameters
<normal>
sets system mode to normal
<admin>
sets system mode to admin
<service>
sets system mode to service
Operation
If specified alone, sysmode displays the system mode. If a mode is specified as a parameter, then the system
mode is changed. This new mode takes effect immediately. The system mode is retained on successive boots.
Interaction with sysmode in a variety of scenarios is outlined below.
Example C-20
sysmode
Command
Shell> sysmode
System Mode: NORMAL
Shell> sysmode admin
You are now in admin mode.
Shell> sysmode service
You are now in service mode.
Shell> sysmode normal
You are now in normal mode
Specifying SCSI Parameters
The following SCSI parameters may be configured for the SCSI board:
•
SCSI ID (SCSI initiator ID)
•
Maximum data transfer rate (SCSI rate)
•
Bus width
•
Whether the HBA is bootable (driver support)
•
Avoid bus resets (secondary cluster server)