Appendix C
Utilities
iLO MP
210
NOTE
The host name is not case sensitive.
Step 8.
The screen displays the current subnet mask name. When prompted to enter a new value or
Q
,
enter the new subnet mask name.
Step 9.
The screen displays the current gateway address. When prompted to enter a new value or
Q
, enter
the new gateway address.
Step 10.
The screen displays the current link state information. When prompted to enter a new value or
Q
,
press
enter
. The message
-> Current Link State has been retained
displays.
Step 11.
The screen displays the current Web console port number. When prompted to enter a new value or
Q,
press
enter
. The message
-> Current Web Console Port Number has been retained
displays.
Step 12.
The screen displays the current SSH console port number. When prompted to enter a new value or
Q,
press
enter
. The message
-> Current SSH Console Port Number has been retained
displays.
NOTE
SSH settings will not display if you do not have Integrated Lights-Out Advanced
Pack licensing.
Step 13.
The screen displays a new
LC
listing, including the values entered in the preceding steps. Verify
that the desired values have been accepted. When prompted to enter a parameter for revision, Y to
confirm, or Q to Quit, enter
Y
to confirm all parameters.
-> Check all LAN parameters to ensure they are correct before commit.
-> “SP_NAME_STR” will be reset if you confirm the changes.
MP Host Name: mpserver
Step 14.
Enter
XD -reset
to reset the iLO MP (only necessary if you are connected through a serial port).
Step 15.
After the iLO MP resets, log in to the iLO MP again. Enter the iLO MP command mode (enter
CM
at the
MP:
prompt).
Step 16.
At the
MP:CM>
prompt, enter
LS
to confirm the new LAN settings.
Step 17.
Enter
SA
to enable or disable the Web console and telnet access after the iLO MP has been reset.
NOTE
HP recommends disabling access methods that you do not intend to use. For example
IPMI over LAN. IPMI over LAN allows access to the iLO MP through the LAN and
has no password by default. HP recommends disabling this port if IPMI management
console software is not being used in your data center (use the
SA
command). If
console management tools are being used, HP recommends using the tools to set a
password on the IPMI over LAN port.
The LC Command Screen
The following screen shows
LC
command output:
MP:CM> LC -nc
Current LAN Configuration:
MAC Address : 0x0060b0f54c51
DHCP Status : Enabled
IP Address : 127.1.1.1