Removing and Replacing Components
Removing and Replacing Internal Components
Chapter 4
98
Shell> sysmode service
Current System Mode: ADMIN
You are now in SERVICE mode.
Step 16.
Use the
sysset
command to enter the product data:
Shell> sysset prodname "server rx2620"
Step 17.
Use the
sysset
command to verify all values are set:
Shell> sysset
System Information:
Manufacturer: hp
Product Name: server rx2620
Product Number: AB332A
Secondary Product Number is Identical
Serial number: US51884101
Secondary Serial Number is Identical
UUID: A8F2D6EC-DBE5-11D9-9172-AE65D056B60F (Valid)
Secondary UUID is Identical
Product ID: 0x10A
Step 18.
Use the EFI
date
and
time
commands to set the correct local date and time.
Step 19.
Review the system configuration in the
Boot Configuration Menu
and/or EFI shell and reconfigure
settings as necessary.
Step 20.
Boot the server and resume normal operation.
Removing and Replacing the Power Supply Interface Module
The power supply interface (PSI) module supports up to two redundant power supplies.
Removing the Power Supply Interface Module
Step 1.
Turn off the server, disconnect all power and external cables, and remove the top metal cover.
Step 2.
Remove the system board. See “Removing and Replacing the System Board” on page 92.
Step 3.
Remove the power supply (or supplies). See “Removing the Power Supply” on page 56.
Step 4.
Lift the power cables out of their metal holding clips. See Figure 4-58 for more information.