3–6
Reference Guide
Using the Wireless LAN
4. Enter the profile information.
5. Tap
Next.
6. Tap “Use server-assigned IP address” and use the DHCP
server address or select “Use specific IP address.”
Field Name
Information
Profile Name
Enter a name for your profile.
SSID
This is the service set identifier (SSID) and the
default is “blank” when connecting to an
infrastructure network. This allows you to
connect to any available access point.
You and the wireless site you want to connect to
must use the same SSID. This identification
number uses a maximum of 32 characters and
is case sensitive.
Power Management
The default selection is “No.” Selecting “Yes”
will provide lower performance and use less
power.
Network
You have two choices: infrastructure or ad
hoc.The default selection is “Infrastructure.”
Use infrastructure to connect to a wired network
via a wireless access point.
Use ad hoc for peer-to-peer communications.
Channel
The default is “Auto.”
You do not need to specify a channel if you are
using an infrastructure network. It will use the
same channel as the access point.
Otherwise, set the frequency that corresponds
to your country’s regulatory commission’s range
and the 802.11b standard.
Transmission Rate
The default is “Auto.”
This is the wireless data transmission
speed. You can select speeds of 1, 2, 5.5,
or 11 Mbps.
281984-001.book Page 6 Thursday, September 26, 2002 5:05 PM
Summary of Contents for iPAQ h5450
Page 1: ...reference guide hp iPAQ Pocket PC h5400 series Document Part Number 281984 001 September 2002 ...
Page 53: ...2 24 Reference Guide Getting Acquainted 3 Tap the Options button 4 Tap the Schedule button ...
Page 85: ...Using the Wireless LAN Reference Guide 3 5 2 Tap Setup 3 Tap the New button ...
Page 251: ...Regulatory Notices Reference Guide A 7 Japanese Notice ...
