Getting to Know Your HP iPAQ
User’s Guide
1–10
To perform a hard reset:
1. Press and hold the
iPAQ Mobile Media
(
) and
iTask
(
) buttons on your HP iPAQ.
2. While holding the
iPAQ Mobile Media
and
iTask
buttons,
use the stylus to lightly press the
Reset
button on the bottom
of your HP iPAQ for about three seconds or until the screen
begins to fade.
3. When the iPAQ screen begins to fade, release the
iPAQ
Mobile
Media
and
iTasks
buttons then remove the stylus
from the
Reset
button. The HP iPAQ resets and powers on.
If the HP iPAQ does not power on after a reset, try the following:
■
Check the battery door to ensure it is locked. If not,
replace the battery door by matching the tabs on the
cover to the latches on the HP iPAQ and snap it into
place. This action locks the battery door. If the battery
door is not locked, the HP iPAQ does not power on. For
more information, refer to “Managing the Battery”
described in this document.
Perform a soft reset on your HP iPAQ. Refer to “How Do I
Regain Functionality if My HP iPAQ Locks Up or Runs Slowly
(Perform a Soft “Normal” Reset)?” described in the How Do I
Guide located on the Companion CD.
Summary of Contents for iPAQ rx3000 series
Page 13: ...Contents User s Guide xiii ...
