14
Chapter 1
Product Information
Front Panel Components
Front Panel Components
Before powering on your system, you should become familiar with the system unit
controls.
Figure 1-1 shows the front panel components with the bezel attached.
Figure 1-1. System Unit Front Panel Controls With Bezel
Figure 1-2. System Unit Front Panel Controls With Bezel Removed
CAUTION
This
workstation
is
designated
for
two-person
lifting.
It
weighs
approximately 36 to 49 pounds (16 to 22 kg), depending on the configuration.
Do not attempt to lift it by yourself, or injury may result.
Power Switch
This switch turns the system on and off. When you turn your workstation off, the operating
system automatically executes the
shutdown -q
command. This prevents any damage to
programs and data on your system disk. Turning the power switch back on again
automatically boots up the HP-UX operating system if your system has been configured to
auto boot.
CD ROM Bay
System LCD
Hard Drive Bays
Power Switch
Captive Thumbscrew
Locking Screw
CD Drive
Hard Disk Drive Bay Areas
System LCD
Summary of Contents for j6700
