HP J8999A, Instructions Manual

ProCurve Networking by HP

Prod. J8999A

ASSEMBLY

Install the articulating mount to the antenna back plane, as
shown in Figure-1:

1. Find the molded antenna mount (3) and four 8-32 nylon lock nuts (4). 

Use the nuts to attach the mount to the exposed studs on the back of 
the antenna.

2. Find the molded articulating arm (2). Also, find a 1/4"-20 x 1-1/4" 

machine screw (5), 1/4" lock washer (6), 1/4" flat washer (7), and 1/
4"-20 hex nut (8). Use hardware to secure the molded arm to the 
antenna mount as shown in Figure-1.

3. For installation on flat surfaces, find the molded wall/mast mount (1) 

and use it as a drill template to mark hole locations. Drill four 3/16" 
diameter pilot holes and install wall anchors (9). Install the mount 
using four 8-18 x 3/4" self-tapping screws (10).

4. For pole or mast installations, find two worm clamps (11) and install 

as shown on the molded wall-mast mount (1). Encircle pole with each 
band and tighten.

5. To attach the antenna assembly to the wall/mast mount, find a 1/4" x 

1-1/4" machine screw (5) and install a 1/4" lock washer (6) and a 1/
4"- flat washer (7) as shown. Use the screw to attach the free end of 
the articulating arm to the mount, securing in place with a 1/4"-20 
nut (8).

6. Loosen 1/4"pivot screws as needed to position antenna for desired 

azimuth and elevation steering. When antenna is in adjusted, tighten 
all hardware securely.

Hardware for MountingAntenna J8999A