2
HP 2.5/6 dBi Dual-Band 6-Element MIMO Omni Directional Antenna (J9659A) Guide
A threaded post on the back of the antenna and a supplied mounting
nut are the primary mounting method when access is available to both
sides of the mounting surface, such as a suspended ceiling tile. Mark
the desired mounting location on the tile and cut a 40mm (1.57”) hole.
Feed the cables through the hole and secure the antenna with the
mounting nut. The included rubber locking gasket should only be used
with the mounting nut when mounting to a hard surface. If access to
the back of the mounting surface is limited, there are two mounting
holes that can be used with #8 screws and expanding anchors (not
supplied).
Connect the three blue antenna leads to an AP radio configured for
5 GHz and connect the three black antenna leads to an AP radio
configured for 2.4 GHz.
ANTENNA PATTERN PLOTS
The plots are oriented as follows:
E0 Plane 270°
E0 Plane 90°
H Plane 0°
E90 Plane 90°
H Plane 90°
E90 Plane 0°
H Plane 180°
E90 Plane 270°
E0 Plane 180°
E0 Plane 0°
E90 Plane 180°
H Plane 270°
Plot Orientation Diagram
320
310
300
290
280
270
260
250
240
230
220
0
350
340
330
210
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
-20
-10
0
dB
2.45 GHz
H Plane
E0 Plane
E90 Plane
5.47 GHz
H Plane
E0 Plane
E90 Plane
320
310
300
290
280
270
260
250
240
230
220
0
350
340
330
210
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
-20
-10
0
dB
5.725 GHz
H Plane
E0 Plane
E90 Plane
320
310
300
290
280
270
260
250
240
230
220
0
350
340
330
210
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
-20
-10
0
dB
