© 2013 Copyright Hewlett-Packard Development Company, L.P.
J8029-90901-NFC_JD_2800w_IG.indd 15
2013-05-31 16:34:51
Notice for the U.S.A
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not
cause harmful interference, and 2) this device must accept any interference received, including interference that may cause
undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
The FCC requires the user to be notified that any changes or modifications made to the device that are not
expressly approved by the Hewlett-Packard Company may void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not
cause harmful interference, and 2) this device must accept any interference received, including interference that may cause
undesired operation.
Warning
: Exposure to Radio Frequency Radiation
Although the radiated output power of this device is below the FCC radio exposure limits, the device should be used in such a
manner that the potential for human contact with the antennas during normal operation is minimized. To avoid the possibility
of exceeding the FCC radio frequency exposure limits, human proximity to the antennas should not be less than 20 cm (8
inches) during normal operation.
Notice for Canada
This device complies with the limits for a Class B digital device and conforms to Industry Canada standard ICES-003. Products
that contain a radio transmitter comply with Industry Canada standard RSS210 and are labeled with an IC ID. Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20 cm between the radiator and personnel.
Note pour le Canada
Cet appareil numérique de la classe B est conforme à la norme ICES-003 d'Industry Canada. La radio sans fil de ce dispositif
est conforme à la certification RSS 210 d'Industry Canada et est étiquetée avec un numéro d’approbation IC.
Le fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas provoquer d'interférences et (2) doit
accepter toute réception d'interférence, y compris les interférences susceptibles de générer un fonctionnement indésirable de
l'appareil.
Cet équipement respecte les limites d'exposition aux radiofréquences canadiennes applicables dans un environnement non
contrôlé. Cet équipement doit être installé et fonctionner à une distance minimale de 20 cm entre le radiateur et votre corps.
Reproduction, adaptation or translation without prior written permis-
sion is prohibited, except as allowed under the copyright laws.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the ex-
press warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional war-
ranty. HP shall not be liable for technical or editorial errors or omissions
contained herein.
La reproduction, l'adaptation ou la traduction de ce document sans
l'autorisation écrite préalable de Hewlett-Packard est interdite, sauf
dans des conditions conformes aux lois relatives au copyright.
Les informations contenues dans ce document peuvent être modifiées
sans préavis. Les seules garanties pour les produits et services HP sont
décrites dans les déclarations de garantie expresses accompagnant
ces mêmes produits et services. Les informations contenues dans ce
document ne constituent en aucun cas une garantie supplémentaire.
HP ne pourra être tenu responsable des erreurs ou omissions de nature
technique ou rédactionnelle qui pourraient subsister dans le présent
document.
Regulatory Model Identification Number
For regulatory identification purposes, this product has been assigned a Regulatory Model Number (RMN). The RMN for your
product is RSVLD-1301. The RMN should not be confused with the marketing name (HP 2800W NFC/Wireless Direct Accessory)
or the Product Number (J8029A).
