2 Installing Accessories in Your PC Workstation
Removing and Replacing the Cover
28
English
Replacing the Cover After Installing Accessories
1
Check that you have installed all your accessories.
2
Check that all internal cables are properly connected and safely
routed so they will not be entangled when you replace the cover.
3
Check that the cover lock is unlocked.
4
Lower the cover onto the computer (aligning the front of the cover
with the inner front edge of the computer frame), and firmly slide it
forwards into position.
5
If required, lock the cover using the key.
6
Replace the front panel by first inserting the two lower hinges then
pivoting it upwards into place. The two tabs will click into place.
7
Close the central latch on top of the front panel.
8
Reconnect all cables and power cords.
Step 4
Step 5
Step 6
Step 7
mamdt.bk : mamdt2.fb4 Page 28 Tuesday, August 5, 1997 4:20 PM
Summary of Contents for Kayak XA
