English
39
2 Installing Accessories in Your PC Workstation
Installing Mass Storage Devices
5
Align the disk drive with the holes in the tray, making sure that the
drive connectors are on the open end of the tray. Then secure the
drive using the screws provided with it.
6
Carefully lower the tray back into position by aligning the metal tabs,
then slide it backwards into place.
7
At the rear of the PC Workstation, replace the retainer bracket and
screw it in place, securing the tray.
8
Connect the power cable and the data cable to the rear of the drive.
The connectors are shaped to go in one way only
. If you are not
sure which connector to use, refer to page 35.
9
Install any other accessories before replacing the power supply unit
and cover. Reconnect all cables and power cords.
10
Refer to page 47 to complete the installation.
Power cable
Data cable
mamdt.bk : mamdt2.fb4 Page 39 Tuesday, August 5, 1997 4:20 PM
Summary of Contents for Kayak XA
