3.
Put the product on its side so that the gear cover faces up. Remove three screws (callout 1) and the
gear cover.
Reinstallation tip
Note the location of the FFC (callout 2) and the shaft (callout 3) for
reinstallation.
Figure 1-177
Remove the Tray 1 or Tray 2 pickup solenoid (2 of 3)
2
1
3
4.
For the Tray 2 pickup solenoid
: Remove one screw (callout 1), and then remove the solenoid
(callout 2).
For the Tray 1 pickup solenoid
: Remove one screw (callout 3), and then remove the solenoid
(callout 4).
Figure 1-178
Remove the Tray 1 or Tray 2 pickup solenoid (3 of 3)
6
1
3
4
5
2
TIP:
Thread the FFC (callout 6) through the gear cover when reinstalling, and make sure to
reinstall the gear (callout 5) if it becomes dislodged.
ENWW
Removal and replacement procedures
119
Summary of Contents for LaserJet Pro M521
