3.
Grip the cover and pull it away from the product. Release the first tab (callout 1), and then release
the second tab (callout 2). Release the third tab (callout 3), if necessary, to separate the cover from
the product.
TIP:
The tab inside the tray cavity (callout 2) is located below the plastic tray rail. It might be
easier to slightly lift up the left side of the product, and use a small flat-tip screwdriver to release
this tab.
Figure 1-33
Remove the left cover (2 of 3)
1
2
3
4.
Rotate the rear of the cover slightly away from the product, and then slide the cover toward the
front of the product to remove it.
Figure 1-34
Remove the left cover (2 of 3)
Reinstallation tip
Align the tabs on the front of the cover first and then reinstall the cover.
ENWW
Removal and replacement procedures
29
Summary of Contents for LaserJet Pro M521
