Removal and replacement procedures 33
2.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Power supply
CAUTION:
For proper cooling, be sure that a component or a component blank is always
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
To remove the component:
1.
Open the cable management arm (on page
2.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Uplink module blank
Summary of Contents for Moonshot 1500
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...