Removal and replacement procedures 35
2.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
HP Moonshot 1500 Chassis Management Module
CAUTION:
For proper cooling, be sure that a component or a component blank is always
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
CAUTION:
Removing the Moonshot 1500 CM module results in the loss of remote management
connectivity for the chassis and both switches. Before removing the module, be sure no remote
sessions are in progress.
CAUTION:
The Chassis UID flashes if a firmware update is occurring in the system. The HP
Moonshot 1500 Chassis Management Module should not be removed while a firmware update
is underway.
To remove the component:
1.
Open the cable management arm (on page
2.
Disconnect all peripheral devices from the chassis.
Summary of Contents for Moonshot 1500
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...