Removal and replacement procedures 42
9.
Disconnect each fan cable from the five fan connector ear pins, and then remove the fan cable.
To replace the component, reverse the removal procedure.
Rear backflow preventer
To remove the component:
1.
Power down the chassis (on page
2.
Open the cable management arm (on page
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
4.
Remove the fans directly above the bay to be serviced ("
" on page
5.
Remove the uplink module or uplink module blank from the bay to be serviced.
Summary of Contents for Moonshot 1500
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...