Removal and replacement procedures 53
17.
Rotate the backplane assembly release lever down and slide the backplane assembly out of the chassis.
To replace the component, reverse the removal procedure. When replacing the backplane assembly, be sure
to hold the backplane assembly level and align it carefully with the guides.
Midplane assembly
WARNING:
The chassis is very heavy. To reduce the risk of personal injury or damage to the
equipment:
•
Always use either a lift that can handle the load of the product or at least four people to lift and
stabilize the product pieces during assembly, installation, or removal, especially when the
chassis is not installed in the rack. An additional person may be required to help align the
chassis if the chassis is installed higher than chest level.
•
Observe local occupational health and safety requirements and guidelines for manual
material handling.
•
HP recommends removing all installed components from the chassis before installing or
moving the chassis.
IMPORTANT:
All components must be removed to service the midplane assembly.
IMPORTANT:
Make note of the cartridge and switch locations before removing them. The
cartridges and switches must be returned to their original locations.
To remove the component:
1.
Power down the chassis (on page
2.
Open the cable management arm (on page
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
4.
Disconnect all peripheral devices from the chassis.
Summary of Contents for Moonshot 1500
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...