Configuring the HP Moonshot System 40
Log in to the iLO CM firmware
After the terminal session is started, log in as administrator at the login prompt.
Enter the username:
Administrator
Enter the password:
password
Obtain the management IP address
To determine the management IP address for the Moonshot 1500 CM module, log in to the iLO CM firmware
while connected to the iLO CM management serial port. At the prompt, enter the following command:
show chassis info
If DHCP services are unavailable on the management network, configure the IP address and network mask
for the Moonshot 1500 CM module. Enter the following commands:
set network ip {<ip_address>}
set network mask {<ip_address>}
Obtain the MAC addresses for each cartridge node
A MAC address is needed to deploy an operating system to a cartridge node.
To obtain the MAC addresses for each cartridge:
1.
Log in to the iLO CM firmware.
2.
Obtain MAC addresses:
show node macaddr all
Configure the iLO CM firmware administrator account password
Log in to the iLO CM firmware and change the administrator account password:
set user password [<user name>] [<new password>]
Example:
set user password Administrator changed_password
For more information about password configuration and restrictions, see the
HP Moonshot iLO Chassis
Management CLI User Guide
in the HP Moonshot Information Library
Update the firmware for the HP Moonshot System components
Enter the following command to flash the specified image file from the NAND or URL to the appropriate
devices.
update firmware {<filename> | <url>}[force] [ <Cx> | sA | sB | all ]
When flashing the iLO firmware, a known good copy of the firmware is kept in reserve until the iLO firmware
is successfully flashed. When flashing cartridges, the command accepts multiple cartridges in the argument.
To flash all cartridges in the chassis, specify
all
in the argument.
Summary of Contents for Moonshot 1500
Page 57: ...Support and other resources 57 ...