MSM310 Access Point Quickstart
5
HP ProCurve Networking
6.
By default, the MSM310 creates a wireless network named
HP ProCurve
. Connect your
computer to this wireless network. For example, in Windows Vista from the
Start
menu,
select
Connect to
, and then
HP ProCurve
from the list of available wireless networks.
You may have to wait a short time for this wireless network name to appear in the
wireless networks list.
7.
Confirm that you can browse the Internet using the wireless network.
G.
Performing additional configuration
Configure your computer LAN port and connect it to the same network as the MSM310. Re-
launch the MSM310 management tool at
https://<
IP address
>
where
<
IP address
>
is the
MSM310 IP address from Step E above.
Note:
See the Caution regarding WIRELESS SECURITY on page 3.
Enabling access to other resources
By default, the MSM310 only permits traffic that is addressed to the default gateway on the
network (which enables you to connect to the Internet). To enable access to other resources:
1.
Select
VSC > Profiles
and then select the
HP ProCurve
profile.
2.
On the
Add/Edit Virtual Service Community
page clear the
Wireless security filters
checkbox.
3.
Select
Save
.
R
egulatory Notice for European Union and EFTA member countries
As of July 1st 2010, all wireless devices sold in EU countries and any countries that participate in the
EU free market must meet stringent Dynamic Frequency Selection (DFS) requirements for radar
detection and avoidance (EN 301.893 v1.5.1). The MSM310 is compliant.
Compliance notes
•
Software version 5.3.5 is released for both rev A and rev B MSM310 APs.
•
On the rev A MSM310, the 5 GHz DFS channels are enabled and can be used.
•
On the rev B MSM310, the following additional 5 GHz DFS channels are disabled and cannot be
used:
•
Channels 52, 56, 60 and 64 in the 5250-5350 MHz band
•
Channels 100, 104, 108, 112, 116, 132, 136 and 140 in the 5470-5725 MHz band.
Note:
Customers will not have to disable these 5 GHz DFS channels on rev A MSM310
APs received prior to July 1st, 2010.
For non-EU/EFTA customers using the WW version of the MSM310, there is no change to the
availability of DFS channels.
