191
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
10.110.2.1 Up 00:16:40 ? 13 0
Anycast RP configuration
Network requirements
As shown in
, the PIM-SM domain in this example has multiple multicast sources and receivers.
OSPF runs within the domain to provide unicast routes.
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can initiate
a Join message to their respective RPs that are the topologically nearest to them.
On Router B and Router D, configure the interface Loopback 10 as a C-BSR and Loopback 20 as a C-RP.
The router ID of Router B is 1.1.1.1, and the router ID of Router D is 2.2.2.2. Set up an MSDP peering
relationship between Router B and Router D.
Figure 56
Network diagram
shows the interface and IP address assignment, and network topology scheme.
Table 16
Interface and IP address assignment
Device Interface
IP address
Source 1
—
10.110.5.100/24
Source 2
—
10.110.6.100/24
Router A
Ethernet 1/1
10.110.5.1/24
Router A
Serial 2/0
10.110.2.2/24
Router B
Ethernet 1/1
10.110.1.1/24
Router B
Serial 2/0
10.110.2.1/24
Loo
p0
Lo
op20
Loop2
0
Loo
p0
P
O
S
5/
0
P
O
S
5/
0
P
O
S
5/1
P
O
S
5/0
S
2/0
S
2/0
S
2/
0
S
2/
0
