Commands
5-15
Results
Check the Windows Event Viewer for a message that indicates that the CE
has been shut down, disabled, or removed from service.
See Also
CE Disable Auto Boot
CE Disable Auto Synch
CE Disable Operation
CE Enable Operation
CE Show Auto Boot
This command shows the state of the Auto Boot parameter for a specific CE. Auto Boot allows
the CE to automatically boot the CE’s Windows operating system after a reboot or power cycle.
By default, Auto Boot is
true
(enabled).
Command
CE
n
Show Auto Boot From IOP
x
Console Syntax
MTCCONS CE
n
Show Auto Boot From IOP
x
Variables
n
– the ID number of the CE (1 or 2)
x
– the ID number of the IOP (1 or 2)
Results
The value for Auto Boot is displayed as either:
true
(enabled) or
false
(disabled). For an example of the results of this command, refer to
CE Show
Parameters
(
5-16
).
See Also
CE Disable Auto Boot
CE Enable Auto Boot
CE Show Parameters
Summary of Contents for NetServer AA 6200
